Opiate refers to any drug that is derived from the opium poppy, including the natural products, Morphine and Codeine, and the semi-synthetic drugs such as heroin. Opioid is more general, referring to any drug that acts on the opioid receptor.

Opioid analgesics comprise a large group of substance which control pain by depressing the central nervous system. Large doses of Morphine can produce higher tolerance levels and physiological dependency in users, and may lead to substance abuse. Morphine is excreted unmetabolized, and is also the major metabolic product of codeine and heroin. Morphine is detectable in the urine for several days after an opiate dose.

The OPI Rapid Test Cassette (Urine) is a rapid urine screening test that can be performed without the use of an instrument. The test utilizes a monoclonal antibody to selectively detect elevated levels of Morphine in urine. The OPI Rapid Test Cassette (Urine) yields a positive result when Morphine in urine exceeds 2,000 ng/mL. This is the suggested screening cut-off for positive specimens set by the Substance Abuse and Mental Health Services Administration (SAMHSA, USA).

 

 

【DIRECTIONS FOR USE】

Test device (in closed pouches), samples, and controls should be brought to room temperature (15-30°C) prior to testing. Do not open pouches until ready to perform the assay.

Remove the test device from its protective pouch and label the device with patient’s identification or control label.

FOR SURFACES

1. Wipe with the panel over the surface in which the drugs are expected.

2. Take off the cap of supplied tube;

3. Fill all buffers from the supplied tube of buffer into the protection cover.

4. Insert the Multi Test slowly and carefully into the protection cover with buffer.

5. Wait for lines to appear on the membrane and read the results after 5 minutes and do not interpret the result after 10 minutes.

 

FOR SOLIDS

1. Open the tube and put the solid in to the buffer.

2. Close the tube with dropper and cap. Shake it a short time. Wait for 30 sec.

3. Take off the cap of supplied tube;

4. Fill all buffers with dissolved substances into the protection cover.

5. Insert the Multi Test slowly and carefully into the protection cover with buffer.

6. Wait for lines to appear on the membrane and read the results after 5 minutes and do not interpret the result after 10 minutes.