【SUMMARY】
Sperm concentration is one of the primary factors used by physicians to diagnose male infertility. There are many reasons why a man may be infertile and therefore unable to fertilize the female ovum during reproduction. One primary and most common reason is an abnormally low production of viable sperm cells. Other reasons can be over production of inactive, weak, or deformed sperm cells, high levels of other cells in the semen that interfere with fertilization, or other physiological factors. Medical or physical conditions may also interfere with normal sperm cell production, including high stress, recent high fever or illness experienced within two months prior to testing, and abrupt changes in diet. Taking this initial screening test will indicate if a low amount of sperm production exists.

Up to 15% of couples experience infertility, which is defined as the failure to become pregnant after one year of unprotected, well-timed intercourse. And, in 40% of couples struggling with infertility issues, male infertility is the primary cause. Because low sperm count is a leading cause of male infertility, an important first step in determining the cause of infertility is to test the sperm count.
The SP-10 Male Fertility Rapid Test Cassette detects Acrosomal Protein SP-10 found on sperms. Since, SP-10 is a protein specific to male germ cells and cannot be found in other cells. This test is very specific for sperms and is now being used for estimating sperm concentration in semen as an aid in determining causes of infertility. The SP-10 Male Fertility Rapid Test detects SP-10 gives a normal result, when sperm concentration is above 15 million/mL in semen – a level internationally accepted as the minimum level of sperms for normal fertility.

【DIRECTIONS FOR USE】
Before testing, read the instructions completely carefully and completely
1. Remove the test cassette from the foil pouch and lay it horizontally on a flat surface.
2. A semen sample should be collected in the collection cup provided.
3. The sample should then be allowed to stand for 60 minutes , until the semen is fully liquefied.
4. Using the semen transfer device provided, fill the Semen transfer device up to 0.1 Ml indicated on the device with the semen sample. The semen sample is then added to the tube of sample dilution buffer provided.
5. Mix the semen sample and sample dilution buffer by turning the tube upside down 5-10 times .
6. Hold the diluted specimen buffer tube upright and open the cap onto the specimen collection tube. Invert the diluted specimen buffer tube and transfer 2 full drops of the diluted specimen (approximately 80 μL) to the specimen well (S) of the test cassette, then start the timer. Avoid trapping air bubbles in the specimen well (S). See illustration below.
7. Read results at 5 minutes after dispensing the specimen. Do not read results after 10 minutes.

 

Cat. No.	Product Description	Specimen	Format	Kit Size	Cut-Off	Status
OSP-902	SP-10 Male Fertility Rapid Test Cassette	Sperm	Cassette	1 T/2T	15 million/mL	CE